XBIB-U【PDF 11/72 页】BOARD USB ZIGBEE MOD PRO

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录58

7页 8页 9页 10页 [11页]12页 13页 14页 15页

XBee/XBeePRO"燨EM燫F燤odules??02.15.4?爒1.xAx燵2007.05.031]

2007燤axStream,營nc.

牋牋?1

Chapter??燫F燤odule燨peration

2.1.4. Flow Control

Figure?03. Internal燚ata燜low燚iagram

DI (Data In) Buffer

When serial data enters the RF module through the DI pin (pin 3), the data is stored in the DI

Buffer until it can be processed.

Hardware Flow Control (CTS

). When the DI buffer is 17 bytes away from being full; by default,

the module de-asserts CTS

(high) to signal to the host device to stop sending data [refer to D7

(DIO7 Configuration) parameter]. CTS

is re-asserted after the DI Buffer has 34 bytes of memory

available.

How to eliminate the need for flow control:

Case in which the DI Buffer may become full and possibly overflow:

Refer to the RO (Packetization Timeout), BD (Interface Data Rate) and D7 (DIO7 Configuration) com-

mand descriptions for more information.

DO (Data Out) Buffer

When RF data is received, the data enters the DO buffer and is sent out the serial port to a host

device. Once the DO Buffer reaches capacity, any additional incoming RF data is lost.

Hardware Flow Control (RTS

). If RTS

is enabled for flow control (D6 (DIO6 Configuration)

Parameter = 1), data will not be sent out the DO Buffer as long as RTS

(pin 16) is de-asserted.

Two cases in which the DO Buffer may become full and possibly overflow:

Refer to the D6 (DIO6 Configuration) command description for more information.

1. Send messages that are smaller than the DI buffer size.

2. Interface at a lower baud rate [BD (Interface Data Rate) parameter] than the throughput

data rate.

If the module is receiving a continuous stream of RF data, any serial data that arrives on the DI

pin is placed in the DI Buffer. The data in the DI buffer will be transmitted over-the-air when the

module is no longer receiving RF data in the network.

1. If the RF data rate is set higher than the interface data rate of the module, the module will

receive data from the transmitting module faster than it can send the data to the host.

2. If the host does not allow the module to transmit data out from the DO buffer because of

being held off by hardware or software flow control.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式